Forklift tires need to have tred on them?

car_guy

i would say it is.

if i am notmistaken OSHA requires that industrial trucks/forsklifts be inspected prior to every use and that any defects or need of repair be noted and addressed immediately and put out of service until corrections have been made. i think that the bald tires will constitute A) lack of traction, thus making it unsafe to workers around and even the operator. B) since the tires will be smaller due to being worn out, the gear ratio will be affected, thus putting the forklift "out of manufacturere's specifications" and altering the manufacturers specs is an osha violation in itself.

shaneinpoco

the only time ive seen tred on forklift tires is when the lift is being used on rough ground. on a concrete floor tires should be smooth for a more comfortable ride.

shade tree mech

Indoors bald Outdoors some tread is needed

JetDoc

Forklifts that work inside warehouses don't need tread on the tires. In fact, most of them come with smooth tires to start with. It's not an OSHA violation. Don't stir up trouble, or you may be looking for a new job!

ARMY GUY

my work has 17 fork lifts cats, yale clarks, nissan, and a couple other brands. ive noticed on the bigger lifts the ones that lift 5000-8000 pounds the tires are bald and they come that way we just got 2 brand new clarks and they have bald tires

Nige

take photos and mail them.

loco_tech85

The deciding factor in this question, is whether or not this forklift is used on a public roadway or just inside a private facility.

If it's being used on a public roadway, then it must comply with that State's laws regarding tires. In some States, rubber tires are permitted up to a point.

However, if the forklift is solely used inside a private facility, then the answer is probably not. This is more of a union problem regarding safety.

lachson

She'll be right mate.

Mindy

i am unable to find actual references or laws on this, but if you are truly concerned for your safety or the safety of others while this forklift is in operation, i would look up your local OSHA rep. and ask them.

UCANTCME

Operatorâ€™s daily checklist for a forklift.

Visual Inspection

Tires/Wheels:
Check tire thread; wear, damage, nuts tight.

Head/Tail/Working Lights:
Check bulbs and if damaged, mounting, operation

Guages/Instruments:
Make sure guages arenâ€™t damage, fully operation

Operator Restraints:
Inspect damaged, mounting, operation, check oil quality.

Enter Your Message or Comment

User Name:
User Email:
Post a comment: